Troubleshooting - Medtronic MiniLink REAL-Time MMT-7703 Gebrauchsanweisung

with the flat side of the MiniLink.
2 Push the tester into the MiniLink until the flexible side arms of the
tester click into the notches on both sides of the MiniLink.
3 Within 20 seconds the green light on the MiniLink will flash for
about 10 seconds when properly connected.
4 Check the sensor icon on the monitor to ensure that the MiniLink
is sending a signal (see the monitor user guide).
Disconnecting the tester
1 Hold the MiniLink body as shown and
pinch the side arms of the tester.
2 With the tester arms pinched, gently
pull the MiniLink away from the tester.
Note: To save MiniLink battery life, do
NOT leave the tester connected
after testing.

Troubleshooting

Question: Why did the flashing green charger light turn off and a
longer flashing red charger light turn on during charging?
about 2 secs
Answer: The MiniLink battery is very low. Leave the MiniLink on
the charger for 8 hours to completely recharge. If the red light is still
flashing after 8 hours, call the HelpLine or your local representative. It
may be time to replace your MiniLink.
Question: Why do I see quick flashing red lights on the charger?
about 2 secs
about 2 secs
about 2 secs
- 7 -
about 2 secs