Medtronic MiniLink REAL-Time MMT-7703 Gebrauchsanweisung Seite 5

(greater separation distance may be required for certain devices).
MiniLink charger
The MiniLink contains a non-replaceable, rechargeable battery that you can
recharge as needed with the charger. The charger has a green light that
shows the charging status and a red light that communicates any problems
during charging. If you see a red light, see the Troubleshooting section. The
charger needs a AAA or LR-03 battery to operate.
Installing a new charger battery
1 Remove charger battery cap by turning it
counter-clockwise 1/4 turn using a coin in the
groove of the cap.
2 Insert a new AAA or LR-03 battery with the
flat (-) end first. Make sure that you align the
small bumps on the battery cap with the small
notches in the charger's battery opening.
Push in the cap all the way using a coin. Turn
the cap clockwise 1/4 turn to close.
3 If the battery is installed incorrectly or is low, the charger will not work.
Repeat the steps above using a new battery.
Note: A new AAA or LR-03 battery contains enough power to recharge the
MiniLink more than 40 times.
Charging the MiniLink
Before using the MiniLink for the first time, you must fully charge the MiniLink
battery which may take up to 8 hours. It is recommended to recharge the
MiniLink after each sensor use. If you choose to recharge the MiniLink after
a 3-day sensor use, the charging time will be less than 20 minutes. A fully
charged MiniLink battery will work more than 14 days without recharging.
After 14 days of use, the MiniLink will fully recharge in less than 2 hours.
Note: When connecting the MiniLink to the charger, always allow at least one
minute before disconnecting or the MiniLink will NOT work properly.
If you disconnect your MiniLink before one minute, reconnect it to the
charger for at least one minute.
- 4 -