Conrad Electronic TE635EL Bedienungsanleitung Seite 61

With the " " or " " button on the back of the weather station, you now have to set the
current altitude of the place where you live. Pressing the corresponding button for a longer
period of time activates the quick adjustment.
With the "PRESSURE/ALTITUDE" button, the settings are accepted and the setting mode
exited, the weather station changes to normal display.
• After a little while, the weather station displays the barometric pressure value on the
display.
• Afterwards, the weather station searches for the existing outdoor sensors (radio reception
icon for outdoor sensors flashes). This takes approx. 2-3 minutes. Wait for that period, do
not press any buttons.

The outdoor sensors send the readings for temperature and air humidity to the
weather station about every 45 seconds. If no data is received for the
respective channel, the weather station only displays dashes for the temperature
and air humidity (e.g. "—.-").
• If no sensor is found, you can start a new sensor search manually by pressing the " "
button on the front for approx. two seconds. The radio reception icon for outdoor sensors
flashes, the weather station searches for the available outdoor sensors (can take 2-3
minutes, do not press any buttons during that time).
• Afterwards, the weather station carries out a signal search for the DCF data (time/date). The
DCF reception icon on the top right of the display flashes.

Do not move the weather station during that time.
It can take 3-10 minutes until the DCF reception is complete and the correct time is shown
on the display.
Further information regarding the DCF reception can be found in the following chapter.
63