Replacing The Fuse; Technical Specifications - EuroLite TC-3 Bedienungsanleitung

The objective lens will require weekly cleaning as smoke-fluid tends to building up residues, reducing the
light-output very quickly. The cooling-fan and the venting slots should be cleaned monthly.
The dichroic colour-filters should be cleaned monthly.
The interior of the device should be cleaned at least annually using a vacuum-cleaner or an air-jet.
There are no serviceable parts inside the device except for the lamp and the fuse. Maintenance and service
operations are only to be carried out by authorized dealers.
Please refer to the instructions under "Installing/Replacing the lamps".

Replacing the fuse

If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of
same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Blackout-connection:
Sound-control:
Radiation angle:
Range of action:
Number of colours:
Dimensions (LxWxH):
Weight:
Fitting lamp:
Maximum ambient temperature t
Maximum housing temperature t
Fuse:
Please note: Every information is subject to change without prior notice. 07/01 ©
230 V/50 Hz
200 W
1
3-pin XLR
¼" mono jack
via built-in microphone
15°
3 - 6 m
7 dichroic + white
175 x 225 x 125 mm
3,15 kg
EFR 15 V/150 W GZ-6,35
: 45° C
a
(steady state): 70° C
B
T 2 A, 250 V
24