Parkside PBSG 95 B1 Originalbetriebsanleitung Seite 7

9. Use protective equipment.
■ Wear safety goggles.
■ Wear hearing protection.
■ Use a dust mask for work that produces a lot
of dust.
10. Connect the dust extraction device.
■ If there are connections for dust extraction,
make sure that these are connected and used
properly.
11. Do not use the cord for purposes for which
it is not intended.
■ Do not pull on the cord to unplug the power
tool. Protect the cord from hot surfaces and
sharp edges.
12. Secure the workpiece.
■ Use clamps or a vice to hold the workpiece
firmly in place. This is safer than simply holding
it in your hand.
13. Avoid any abnormal posture.
■ Keep proper footing and balance at all times.
14. Maintain tools with care.
■ Keep the cutting tools sharp and clean to be
able to work better and more safely.
■ Follow the instructions on lubrication and
exchanging tools.
■ Check the power cord regularly and have it re-
placed by a certified specialist if it is damaged.
■ Check extension leads regularly and replace
them if they are damaged.
■ Keep the handles dry, clean and free from oil
and grease.
15. Unplug the appliance from the mains socket.
■ when the power tool is not in use, before main-
tenance and when changing tools such as saw
blades, drill bits and milling tools.
16. Never leave any tool key attached.
■ Check that all keys and adjusting wrenches are
removed before switching on.
│ GB │ IE
■ 4
17. Avoid unattended start-up.
■ Ensure that the switch is switched to off before
inserting the plug into the wall socket.
18. Use the extension cord for outdoor use.
■ Use only suitably certified and labelled extension
cords outdoors.
19. Remain alert at all times.
■ Pay attention to what you are doing. Proceed
with caution when working with the tool. Do not
use the power tool if you lack concentration.
20. Check the power tool for any damage.
■ Before continuing to use the power tool, check
all safety devices and slightly worn parts to
make sure they function properly and as
intended.
■ Check whether moving parts work properly and
do not jam or whether parts are damaged. All
parts must be properly fitted and meet all the
conditions to ensure the proper operation of the
power tool.
■ Damaged safety devices and parts must be
properly repaired or replaced by a specialist
workshop unless otherwise indicated in the
instructions.
■ Damaged switches must be replaced at an
authorized customer service centre.
■ Do not use any power tools that you cannot
switch on and off with the power switch.
21. ATTENTION!
■ The use of other tools and accessories could
lead to an increased risk of personal injury for
you.
22. Have your power tool repaired by a qualified
electrician.
■ This power tool complies with all pertinent safety
regulations. Repairs may only be performed
by a qualified electrician using original spare
parts; otherwise this could lead to accidents for
the user.
PBSG 95 B1