WimTec Rohbauset W6 Montageanleitung Seite 8

EN
Flush-mount set W6 (- TD)
General notes
WimTec
8 Flush-mount set
This manual is valid for the following products:
Art.Nr. 119 961 WimTec Flush-mount set W6
Art.Nr. 119 978 WimTec Flush-mount set W6 - TD
Delivery scope:
Wall box with 2 shut-off valves and integrated dirt fi lters and refl ux
fi lter, thermostat with adapter, 1 magnetic valve (2 magnetic valves
for thermal disinfection), WimTec supply cable 3m and cover plate.
Important installation notes:
Provide for a fl ush-mount box for an optional power supply outside of
the protected zone. Mounting and installation may only be performed
by a qualifi ed service provider in accordance with DIN 1988, ÖVE/
ÖNORM E8001 and VDE 0100 Part 701. When planning and installing
sanitary facilities, all relevant local, national and inter-
national standards and provisions must be observed!
According to the Austrian ÖNORM B 5019, thermal disinfection requires
a minimum temperature of 60 °C for at least 10 min at the relevant
system locations. The operator must ensure that all parts of the
installation (e.g., piping) can withstand the temperatures applied
during thermal disinfection.
The "General installation terms and conditions"
!
provided at www.wimtec.com apply.
W6