Hama EWS-860 Bedienungsanleitung Seite 8

Display
Display flashing
Displayed continuously
Displayed continuously
6.2. Selecting the channel/other measuring stations
Note
• You can install two more measuring stations in addition to the included measuring
station. Ensure that the base and measuring stations are set to the same channel.
Visit www.hama.com for suitable measuring stations.
• The transmission channel on the supplied measuring station cannot be changed/set
(CH1).
• Press the channel button (22) repeatedly to set the channel to that set on the respective
measuring station. CH1, CH2 or CH3 (4) is displayed.
• Select CH1 if you are only using the measuring station supplied.
• The base station now shows the data measured (16, 6) on the selected measuring station
(4).
• Press and hold the channel button (22) to select the channel scan. The
measurement values of the individual measuring stations/channels (4) are displayed
consecutively for 5 seconds each.
6.3. Basic and manual settings
Automatic setting using the DCF signal
After the first time the base station is switched on and successful transmission is established
between the base station and the measuring station, the clock will automatically search for a
DCF signal. During the search, the wireless symbol (12) will flash.
Search for a signal from the measuring station
Successful – signal is being received
Inactive – no signal reception for > 1 hour
Active
symbol and
7