Hama EWS-860 Bedienungsanleitung Seite 7

5.1. Base station
• Use the base to position the base station on a level surface. (C)
5.2. Measuring station
• You can fasten the measuring station horizontally or vertically to an outer wall using a
mounting plate (26).
• If you want to mount the measuring station horizontally, use rawl plugs, screws, etc. to
fasten the mounting plate (26) using the central cut-out (28) to the wall intended for
installation.
• If you want to mount the measuring station vertically, use rawl plugs, screws, etc. in the
wall intended for installation and hang the mounting plate (26) using cut-out (27).
• Gently push the measuring station until you hear a latching sound ("click") as it engages
with the clips (29).
6. Operation
Note – Input
Hold down the
6.1. Connection to the measuring station
• After you insert the batteries, the base station automatically searches for a connection to
the measuring station and performs initial setup.
Note
• Initial setup takes approx. 3 minutes.
• During connection, the wireless symbol on the measuring station will flash (3).
• Do not press any buttons during setup. Otherwise, values may not be transmitted
correctly and there is a risk of value errors and inaccuracies.
• The setup process is completed when the indoor (18, 14) and outdoor (6, 16)
measurement data is displayed.
• If the base station still does not receive a signal from the measuring station, press and hold
the - button (19) for approx. 3 seconds to start the manual search for the signal.
6
button (18) or the
-
button (19) to select the values faster.
-