Inhaltsverzeichnis
Werbung
Ventilation
Fig. 2
The air on the rear panel of the appliance
heats up. The warm air must be able to
escape. Otherwise, the refrigerator must
work harder. This will increase the power
consumption.
For this reason pull up the spacers
provided on the appliance's rear panel for
the optimum distance to the wall Fig. 3.
Never cover or block the ventilation
openings!
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for
the first time, clean the interior of the
appliance (see chapter Cleaning).
The socket should be freely accessible.
Connect the appliance only to
220 240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with a 10 A
to 16 A fuse.
If the appliance is to be operated in
a non European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the bottom
left hand side of the appliance. The power
cord may be replaced by a technician
only.
Warning
!
Never connect the appliance to electronic
energy saver plugs or to power inverters
which convert the direct current to 230 V
alternating current (e.g. solar equipment,
power supplies on ships).
Switching on
the appliance
Press the main switch, Fig. 1/1.
The appliance starts refrigerating.
At the factory the refrigerator
compartment was set to +10 ºC.
Selecting the
temperature
The set values can be changed,
see Description of control panel.
en
21
Werbung
Inhaltsverzeichnis
