BabySafe Schnauzer Anleitung Seite 45

INSTALLING THE CAR SEAT ONTO THE BASE
Place the car seat onto the car seat base facing in the direction of
travel and press the car seat down until you hear a „click" (12).
The car seat can be set in any of its 4 recline positions, to recline the
car seat see section „RECLINING YOUR CAR SEAT". To remove the
car seat from the base, simultaneously press the car seat release
button (Y) while lifting the car seat up out of the base (13, 14).
INSTALLING YOUR CHILD IN THE CAR SEAT
Firstly open the buckle by pressing the red button in the centre
of the buckle (27). Then sit your child in the car seat, passing their
arms through the shoulder straps.
Bring the harness connectors together and insert into the buckle
until you hear a „click" (28).
Tighten the harness by pulling on the harness adjustment strap
(29), once tight make sure that there is no more than a fingers
width between the harness and your child.
The child's head should sit directly in the middle of the headrest
and the sides of the headrest should sit just above the child's
shoulders, and the shoulder straps should be level with or above
your child's shoulders (26). If this is not the case please refer to
section „Headrest and Safety Harness Adjustment".
CHECKLIST
WARNING! A CORRECTLY ADJUSTED HARNESS IS ESSENTIAL FOR
YOUR CHILD'S PROTECTION. THERE SHOULD NOT BE MORE THAN
A FINGERS WIDTH BETWEEN THE HARNESS AND YOUR CHILD.
However safe a child seat is, however well built it is, your child's
safety depends on you carrying out the following checks before
every journey.
19