BabySafe Schnauzer Anleitung Seite 38

INSTALLING THE BASE - with a seat belt
Please Note: that your car seat is designed to fit only with a 3 point lap
and diagonal seat belt and must not at any time be fitted using only a 2
point lap belt (1).
IMPORTANT! Only use the red adult seat belt guides (G) and no other
load bearing points. Check if the adult seat belt buckle is forward of
the seat belt guides (G) on the car seat, or is in a position that interferes
with the seat belt fixing points, as it may not be possible to get a secure
installation of the car seat. If this is the case, please try another seating
position in the vehicle. If in doubt please contact our customer service
department.
WARNING! ALWAYS GIVE PREFERENCE TO USING THE REAR SEATS OF
YOUR VEHICLE EVEN IF YOUR HIGHWAY CODE PERMITS THE USE ON THE
FRONT SEAT. CHECK YOUR HIGHWAY CODE AS THIS REGULATION MAY
VARY ACCORDING TO THE COUNTRY. CHECK THE VEHICLE MANUAL FOR
ADVICE ON FITTING YOUR CAR SEAT IN THE FRONT OF THE VEHICLE.
AIRBAGS CAN CAUSE INJURY. DO NOT USE THIS CHILD SEAT ON A
PASSENGER SEAT FITTED WITH A FRONTALAIRBAG.
Ensure the ISOFIX points are fully retracted. To do this, squeeze together
the ISOFIX adjustment buttons (R) located on either side of the support
leg at the front of the car seat base, and pull the support leg towards you.
Fold out the support leg fully and place the car seat base onto the vehicle
seat (3).
Open the central red belt lock (H) (4). Extract the vehicle seat belt and
pass across the base.
Pass the lap section under both belt guides (G) making sure it also passes
through the belt lock (6) and pull the belt tight. Then insert the vehicle
seat belt connector (V) into the vehicle buckle (W) (5).
Next pass the diagonal section under both belt guides (G) making sure
it also passes through the belt lock (6). Ensure that the seat belt Is pulled
tight and is not twisted. Then close the belt lock to secure the seat belt
in place (7).
12