BabySafe Schnauzer Anleitung Seite 40

Squeeze together the ISOFIX adjustment buttons (R) located on either
side of the support leg at the front of the car seat base, and push the
support leg towards the seat base to extend the isofix attachment points
(15).
Line the isofix attachment points with the isofix latches in the vehicle
seat (16), and push the isofix points into the isofix latches until you hear
a „click".
When the isofix points are correctly attached, the isofix connection
indicators (S) will turn green (17) if the indicators remain red you must
release and re connect the isofix points, to do this see section „REMOVING
THE BASE -when attached to the ISOFIX points".
Once the isofix points are correctly attached, push the base towards the
vehicle seat backrest until firm (18).
IMPORTANT! Always use the support leg when the car seat base is fitted
into the vehicle.
WARNING! ENSURE THAT AT ALL TIMES THE SUPPORT LEG IS IN CONTACT
WITH THE FLOOR OF THE VEHICLE AND THE INDICATORS ARE GREEN.
To adjust the support leg, pull the support leg adjustment button (T)
located on the back of the support leg and move the foot of the support
leg downwards until it reaches the vehicle floor (8).
When the support leg is locked into position your will hear a „click" (9).
IMPORTANT! Make sure that the support leg indicator (V) is green. If the
indicator is red you must re-adjust the support leg.
CHECKLIST
To ensure the optimum safety of your child, check the following after
installation:
- Check that the isofix points are securely attached to the vehicle by
checking that the indicators on the isofix points (S) are green (17)!
- Check that the support leg is fully folded out (3), that the lower part of
the leg is locked into position and the indicator on the foot of the support
leg is green (8)!
14