Check List - BabySafe Schnauzer Anleitung

IMPORTANT! Always use the support leg when the car seat base
is fitted into the vehicle.
WARNING! ENSURE THAT AT ALL TIMES THE SUPPORT LEG IS IN CONTACT
WITH THE FLOOR OF THE VEHICLE AND THE INDICATOR IS GREEN.
To adjust the support leg, pull the RED support leg lock (T) located on the
of the support leg and extend the lower section of the support leg until it
reaches the vehicle floor (8). When the support leg is locked into position
you will hear a „click". If the lock does not engage, extend the leg to the
next lock position.
IMPORTANT! Make sure the indicator (U) on the support foot is green. If the
indicator is red you must re-adjust the support leg. To remove the car seat
base from the vehicle simply open the belt lock and remove the seat belt.
CHECKLIST
To ensure the optimum safety of your child, check the following after
installation:
- Check that the seat belt is as tight as possible and not twisted!
- Check that the diagonal and lap section of the vehicle belt pass
under the two red belt guides and through the red belt lock (6) (7)!
- Check that the support leg is fully extended to the floor (3) and
locked into position and the indicator on the foot of the support leg
is green (8)!
- Check that the car seat base is installed securely and firmly in the
vehicle by trying to move it!
INSTALLING THE BASE - with ISOFIX
WARNING! ALWAYS GIVE PREFERENCE TO USING THE REAR SEATS OF
YOUR VEHICLE EVEN IF YOUR HIGHWAY CODE PERMITS THE USE ON THE
FRONT SEAT. CHECK YOUR HIGHWAY CODE AS THIS REGULATION MAY
VARY ACCORDING TO THE COUNTRY. CHECK THE VEHICLE MANUAL FOR
ADVICE ON FITTING YOUR CAR SEAT IN THE FRONT OF THE VEHICLE.
AIRBAGS CAN CAUSE INJURY. DO NOT USE THIS CHILD SEAT ON A
PASSENGER SEAT FITTED WITH A FRONTALAIRBAG.
Fold the support leg out and place the car seat base onto the
vehicle seat (3).
13