BabySafe Schnauzer Anleitung Seite 41

- Check that the car seat base is installed securely and firmly in the vehicle!
REMOVING THE BASE - when attached to the ISOFIX points Squeeze
together the two isofix connection adjustment buttons (R) located on
either side of the support leg at the front of the car seat base and pull the
away from the vehicle seat (20).
Unlock the isofix points (Z) by pulling both latches (Q) toward the front of
the vehicle seat (21 ).
Then pull the car seat base forward on the vehicle seat to release from
the vehicle (22).
REARWARD FACING FOR GROUP O+
(Birth to 13kg / birth to approx. 18 months)
Firstly you must install the car seat base into your vehicle using either the
seat belt or ISOFIX points. See sections „Installing the base - with a seat
belt' or ‚Installing the base - with ISOFIX".
You must also ensure that the harness and headrest is set correctly
for your child, to do this see sections ‚Headrest and Safety Harness
Adjustment' and „Harness Tension and Adjustment".
The car seat can be used with an optional seat liner and head hugger (C1)
for small babies, which is available as an accessory. Please contact your
dealer for further information.
INSTALLING THE CAR SEAT IN TO THE BASE FULLY RECLINED
Firstly make sure that the seat is in its fully reclined position. First click
the metal bar on the backrest side of the car seat into the base of the
Varioguard and then the frontal side (9). Each time you should hear a clear
CLICK. Make sure that the safety indicator (V1) fully turned GREEN. (19)
Check the seat is secure by lifting the seat upwards. To remove the car
seat from the base, press the car seat release button (Y) at the front of the
base while lifting the car seat up from the base ( 10, 11 ).
INSTALLING YOUR CHILD IN THE CAR SEAT
Firstly open the buckle by pressing the red button in the centre of The
buckle (26). Then sit your child in the car seat, passing their arms through
the shoulder straps.
15