BabySafe Schnauzer Anleitung Seite 43

You must also ensure that the harness and headrest is set cor rectly
for your child, to do this see sections „Headrest and Safety Harness
Adjustment" and ‚Harness Tension and Adjustment' . The car seat can be
used with an optional seat liner and head hugger (C1) for small babies,
which is available as an accessory. Please contact your dealer for further
information.
INSTALLING THE CAR SEAT INTO THE BASE FULLY RECLINED
Firstly make sure that the seat is in its fully reclined position, then place
the car seat onto the base facing towards the rear of the vehicle and press
the car seat down until you hear a „click" (9). Check the seat is secure by
lifting the seat upwards.
To remove the car seat from the base, at the same time press the car seat
release button (Y) while lifting the car seat up from the base (10, 11).
INSTALLING YOUR CHILD IN THE CAR SEAT
Firstly open the buckle by pressing the red button in the centre of the
buckle (27). Then sit your child in the car seat, passing their arms through
fhe shoulder straps.
Bring the harness connectors together and insert into the buckle until
you hear a „click" (28).
Tighten the harness by pulling on the harness adjustment strap (29), once
tight make sure that there is no more than a fingers width between the
harness and your child.
The child's head should sit directly in the middle of the headrest and the
sides of the headrest should sit just above the child's shoulders, and the
shoulder straps should be level with or below your child's shoulders (25,
26).
If this is not the case please refer to section ‚Headrest and Safety Harness
Adjustment' .
CHECKLIST
WARNING! A CORRECTLY ADJUSTED HARNESS IS ESSENTIAL FOR YOUR
CHILD'S PROTECTION. THERE SHOULD NOT BE MORE THAN A FINGERS
WIDTH BETWEEN
17