Display (In Video Mode); Lamp - Dell 2400MP Benutzerhandbuch

T —Synchronize the phase of the display signal with the graphic card. If you
RACKING
experience an unstable or flickering image, use Tracking to correct it. This is a fine
adjustment.

DISPLAY (in Video Mode)

automatically switches to CUSTOM.
S T —Manually select signal type RGB, YCbCr, YPbPr.
IGNAL YPE
Z —Press to digitally magnify an image to 10 times on the projection screen
OOM
and press to reduce the zoomed image.
W I —Setting 0 to maximize the color reproduction and 10 to
HITE NTENSITY
maximize the brightness.
D —Adjust among the 4 preset values to change the color performance of
EGAMMA
the display.

LAMP

the projector enters power saving mode and turns off the lamp. The projector
turns back on when it detects an input signal or when you press the power button.
After two hours, the projector turns off or when you press the power button to turn
the projector on.
V M —Select a mode
IDEO ODE
to optimize the display on
how the projector is being
used: PC, MOVIE, sRGB
(provides more accurate
color representation),
GAME , and CUSTOM
(set your preferred settings).
If you adjust the settings for
White Intensity or
Degamma, the projector
L H —Display the
AMP OUR
operating hours since the
lamp timer reset.
P S —Select ON
OWER AVING
to set the power saving
delay period. The delay
period is the amount of
time you want the projector
to wait without signal
input. After that set time,
Using Your Projector 27