Dell 2400MP Benutzerhandbuch Seite 41

RS232 Protocol
• Communication Settings
Connection settings
Baud Rate:
Data Bits:
Parity
Stop Bits
• Command types
To pop up the OSD menu and adjust the settings.
• Control command Syntax (From PC to Projector)
[H][AC][SoP][CRC][ID][SoM][COMMAND]
• Example: Power ON Command (Send low byte firstly)
--> 0xBE, 0xEF, 0x10, 0x05, 0x00, 0xC6, 0xFF, 0x11, 0x11, 0x01, 0x00, 0x01
Header "BE EF"
Address Code "10" ==> pt_OEM
Payload Size "05 00"==> From wMsgID to end
CRC "C6 FF" ==> If CRC value is "C6 (Low Byte) FF (High Byte)"
MsgID "11 11"
MsgSize "01 00"==> From command to end.
Command "01"==> "Power ON" command.
• Projector Response Message Table:
0x00: Success
0x01: Invalid command (on the control command list but not valid. e.g. card reader
command while no card reader plug-in)
0x02: Error command (includes CRC error and unknown commands).
0x03: System Status - Projector ON (Normal Mode).
NACK: System Status - Projector OFF (Standby Mode).
RS232 Pin Assignment
Value
19200
8
None
1
Specifications 41