Display (In Video Mode); Lamp - Dell 1800MP Benutzerhandbuch

V P —Press
ERTICAL OSITION
and to adjust the vertical position of the image up.
F —Change the display data clock frequency to match the frequency of
REQUENCY
your computer graphics card. If you see a vertical flickering bar, use Frequency
control to minimize the bars. This is a coarse adjustment.
T —Synchronize the phase of the display signal with the graphic card. If you
RACKING
experience an unstable or flickering image, use Tracking to correct it. This is a fine
adjustment.

DISPLAY (in Video Mode)

If you adjust the settings for White Intensity or Degamma, the projector
automatically switches to CUSTOM.
S T —Manually select signal type RGB, YCbCr, YPbPr.
IGNAL YPE
W I —Setting 0 to maximize the color reproduction and 10 to
HITE NTENSITY
maximize the brightness.
D —Adjust among the 4 preset values to change the color performance of
EGAMMA
the display.

LAMP

time, the projector enters power saving mode (Power light in Orange) and turns
off the lamp. The projector turns back on when it detects an input signal or when
you press the power button. After two hours, the projector automatically turns off
(Power light in Blue), press the power button to turn on the projector again.
to adjust the vertical position of the image down
V M —Select a mode
IDEO ODE
to optimize the display on
how the projector is being
used: PC, MOVIE, sRGB
(provides more accurate
color representation),
GAME , and CUSTOM
(set your preferred settings).
L H —Display the
AMP OUR
operating hours since the
lamp timer reset.
P S —Select ON to
OWER AVING
set the power saving delay
period. The delay period is the
amount of time you want the
projector to wait without
signal input. After that set
Using Your Projector 25