Display (In Pc Mode) - Dell 2400MP Benutzerhandbuch

S —Adjust a video source from black and white to fully saturated color.
ATURATION
Press to decrease the amount of color in the image and
amount of color in the image.
S —Press
HARPNESS
sharpness.
to increase the amount of green in the image and
T —Press
INT
increase the amount of red in the image.

DISPLAY (in PC Mode)

Z —Press
to digitally magnify an image to 10 times on the projection screen
OOM
and press to reduce the zoomed image.
W I —Setting 0 to maximize the color reproduction and 10 to
HITE NTENSITY
maximize the brightness.
D —Adjust among the 4 preset values to change the color performance of
EGAMMA
the display.
H P
ORIZONTAL OSITION
the left and to adjust the horizontal position of the image to the right.
V P —Press
ERTICAL OSITION
and to adjust the vertical position of the image up.
F —Change the display data clock frequency to match the frequency of
REQUENCY
your computer graphics card. If you see a vertical flickering bar, use Frequency
control to minimize the bars. This is a coarse adjustment.
26 Using Your Projector
to decrease the sharpness and
to adjust the horizontal position of the image to
—Press
to adjust the vertical position of the image down
to increase the
to increase the
V M —Select a mode
IDEO ODE
to optimize the display on
how the projector is being
used: PC, MOVIE, sRGB
(provides more accurate
color representation),
GAME , and CUSTOM
(set your preferred
settings). If you adjust the
settings for White
Intensity or Degamma, the
projector automatically
switches to CUSTOM.
S T —Manually
IGNAL YPE
select signal type RGB,
YCbCr, YPbPr.
to