Changing The Battery In The Remote Control; Changing The Batteries In The Wind Sensor - Dometic PerfectRoof PR4500 Bedienungsanleitung

Operating the awning
6.5

Changing the battery in the remote control

I
NOTE
If the LED in the remote control does not light up after pressing
one of the buttons, the remote control battery is flat.
➤ Remove the screw (fig. 3 2, page 2) on the back of the remote control.
➤ Open the housing of the remote control.
➤ Remove the old battery from the holder.
➤ Insert the new CR2430 (3 V) battery type into the holder with the positive
terminal facing upwards.
➤ Reassemble the remote control.
B
Protect the environment!
Do not dispose of any batteries with general household waste.
Return defective or used batteries to your retailer or dispose of
them at collection points.
6.6

Changing the batteries in the wind sensor

I
NOTE
When the batteries in the wind sensor are running low, the awning
retracts automatically after 30 minutes, even if it is not windy.
➤ Extend the awning if required.
➤ Move the wind sensor (fig. 5 1, page 3) on the inside of the front cover
to the left and take it off.
➤ Release the sensor insert with a screwdriver (fig. 6 A, page 3).
➤ Remove the sensor insert from the housing (fig. 6 B, page 3).
I
NOTE
Do not use rechargeable batteries.
➤ Replace the used batteries with new AAA or LR03 (1.5 V) alkaline batter-
ies (fig. 6 C, page 3). Make sure the polarity is correct.
✓ After correctly inserting the new batteries, the LED (1) lights up for about
1 second (fig. 6 D, page 3).
40
PR4500
EN