Extron COMMANDER 3 Bauanleitung Seite 4

2. SICHERHEITSHINWEISE / SAFETY INSTRUCTIONS
GENERAL SAFETY INSTRUCTIONS FOR ELECTRIC MODELS
• This is not a toy! Suitable for young people under the age of 14 with adult supervision.
• Use the model accordingly to chapter "How To Use" in this instruction manual.
• Assemble the model accordingly to this instruction manual. Do not alter or modify the model. Only use parts that are ofcially
recommended by extron Modellbau.
• Always pay close attention to the manuals that are included to accessory parts (radio system, speed controller, battery etc.).
• Do not fly the model before you have fnished the assembly completely according to this manual.
• Before you fly, check all functions of the model carefully.
• Never fly your model near other human beings, animals or other obstacles. You are responsible for flying the model, so
you have to check carefully your flight area.
• NEVER use your model on public streets or near public airports.
• Stop flying immediately if you realize any radio interference.
• Do not touch any moving or hot motor parts during action! Let all components cool down before you handle them.
• Check your model carefully after each flight. Replace parts if they are worn out or if they are defective.
• Keep your hands out of reach from rotating or hot parts of the model.
• Keep in mind that plastic parts easily break under cold temperature conditions.
• If you are a novice in flying you should ask experienced pilots for assistance during your frst flights.
• Protect yourself from dust and other small things when you test run your propeller drive on the ground.
• Keep all electronic components dry and clean!
• Take care that your motor does not get overload or gets blocked under full power.
• Let the motor cool down after restarting the model again.
• Charge your batteries carefully. Always watch the charging process and make sure all connectors are in good
conditions.
• Do not shorten the battery by connecting the pluspole with the minuspole directly!
• Make sure that the wires do not touch rotating or hot parts of the model.
• Check the kit before assembly for completeness and proper fit.
4
Manual Commander 3.indd 4
MODELLBAU
Art.-Nr. / Item-No. X8981/X8982
07.11.17 11:00