Xoro HSD 7799 Bedienungsanleitung Seite 74

Move to Installation and press OK, then a submenu shall be popped up which includes three
options:
x
Auto Scan
x
Channel Scan
Auto Scan
Scan Mode: Free (scan all free channels), All
(scan all channels including free and paid ones);
Search: Press OK to display Scan box and
conduct auto scan, or press SETUP or EXIT to
quit. The scan box indicates the scan process by
percentage of completion;
details about Scan
Demodulation mode, Channel No, Transmission
mode and Guard Interval etc.; Below are the
scanned TV channels
displayed in two columns.
Channel Scan
x
Scan Mode:
Frequency. Either alternative shall be fine
for scan.
x
Scan Band: VHF/ UHF available.
x
Ch No. : Channel 5~12 ( VHF), and
Channel 21~69 (UHF)
x
Frequency:
470~862 MHz (UHF) are available.
(The frequency system can be set
automatically according to different
regions, and the actual frequency point
should be referred to the practice).
x
Band Width: There are three options: 6
MHz, 7 MHz, and 8 MHz.
x
Search: Move the cursor here and
press OK, then a information box shall
appear indicating the scanning process.
Pressing Exit allows you to cancel scan
and quit current interface. The scan
process box shows the progress of
scan by percentage of completion; On
the top there is detail about Scan Band, Frequency, Demodulation modes, Channel No,
Transmission mode and Guard Interval etc.; Below are the scanned TV channel list and
radio channel list displayed in two columns.
Notes:
1. Only when Scan Mode is set to "By Channel", can Scan Band and Ch No be ready for setup.
2. Only when Scan Mode is set to " By Frequency", can Frequency and Band Width be set.
ENG-34
DVB-T Setup
On the top there is
Band, Frequency,
and radio channels
By Channel and
174~230 MHz (VHF),
HSD 7799
By