Installing The Wireless Camera - Conrad 75 18 00 Bedienungsanleitung

• Vibration-free
• No direct sunlight
Select a place for mounting which is not shielded by, for example, reinforced con-
crete walls, steamed up mirrors or metal shelves. There should be no devices with
strong electrical fields, such as mobile telephones, radios or electrical motors, close
to the device. This may interfere with radio transmission or restrict the range. Heat
sources may also lead to malfunctioning or defects.
Do not point the camera directly toward bright sunlight or toward strong or direct
light sources as this may lead to overexposure.
7.1 Installation of the wireless camera
None of the connecting cables must be bent or squeezed. This can result in mal-
functions, short circuits and defects in the device.
Make sure you do not damage any cables or power lines when drilling holes in the
wall or fastening screws.
The camera is suitable for outdoor use (IP44).
Do not point the camera directly toward bright sunlight or toward strong or direct
light sources as this may lead to overexposure.
Wall mounting:
Ceiling mounting
• Select a suitable mounting place for the camera.
• There are installation holes on the support. Copy
these on the wall (e.g. with a pencil) .
• Drill the holes into the wall.
• Attach the mounting bracket to the wall using suit-
able mounting material.
• Attach the camera onto the mounting base.
• Adjust the camera to the desired position.
• Tighten the fastening screws of the mounting base.
33