Front Panel / Generalities; Usb Port; Remove The Dcp; Attach The Dcp - Clarion CZ702E Benutzerhandbuch & Installationshandbuch

Front Panel / Generalities

For a longer service life, be sure to read the following cautions.
• Do not allow any liquids on the unit from drinks, umbrellas, etc. Doing so may damage the
internal circuitry.
• Do not disassemble or modify the unit in any way. Doing so may result in damage.
• Do not let cigarettes burn the display. Doing so may damage or deform the body.
• If a problem should occur, have the unit inspected at your store of purchase.
• The remote control unit may not work if the remote control sensor is exposed to direct sunlight.
Cleaning the body
• Use a soft, dry cloth and gently wipe off any dirt or dust.
• For tough dirt, apply some neutral detergent diluted in water to a soft cloth, wipe off the dirt
gently, then wipe again with a dry cloth.
• Do not use benzene, thinner, car cleaner, etc., as these substances may damage the body or
cause the paint to peel. Also, leaving rubber or plastic products in contact with the body for long
periods of time may cause stains.

USB Port

• The USB memory sticks must be recognized as "USB mass storage class" to work properly.
Some models may not operate correctly.
When the memorized data is lost or damaged by any chance, Clarion shall not be liable
for any damage.
When using an USB memory stick, we recommend that you backup your data stored on it before
using a personal computer etc.
• Data files may be broken when using USB memory sticks in the following situation: When
disconnecting the USB memory stick or turning the power off during reading data.
When affected by static electricity or electric noise.
Connect/disconnect the USB memory stick when it is not accessed.
• Connecting with the computer is not covered.
4
CZ702E

Remove the DCP

The control panel can be detached to prevent
theft. When detaching the control panel, keep
it in the safety place and prevent scratches.
W e r e c o m m e n d t a k i n g t h e D C P
(DETACHABLE CONTROL PANEL) with you
when leaving the car.
1. Press the [SRC / ] button (1 sec.) to turn
off the power.
2. Deeply push in [OPEN] button to unlock
the DCP.
3. Hold the side popped out, remove the
DCP.

Attach the DCP

1. Hold the DCP and ensure that the panel
faces towards you. Set the right side of the
DCP into the DCP bracket.
2. Press the left side of the DCP until it locks.

Storing the DCP in the DCP Case

Hold the DCP, as shown in the figure below,
and put it into the supplied DCP case.
DCP
DCP case
Note:
If the DCP is dirty, wipe off the dirt with a soft,
dry cloth only.
CAUTION
• The DCP can easily be damaged by
shocks. After removing it, be carefully not
to drop it or subject it to strong shocks.
• Once the [OPEN] button is pressed and
DCP is unlocked, car vibrations can cause
the DCP to fall
• The connector for the main unit and
DCP is extremely important. Be careful
not to damage it by pressing on it with
fingernails, screwdrivers, etc.