Machine Information - Ferm AGM1067P Übersetzung Der Originalbetriebsanleitung

their own weight. Supports must be placed
under the workpiece near the line of cut and
near the edge of the workpiece on both sides
of the wheel.
f) Use extra caution when making a "pocket
cut" into existing walls or other blind areas.
The protruding wheel may cut gas or water
pipes, electrical wiring or objects that can
cause kickback.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate label.
Class II machine - Double insulation - You
don't need any earthed plug.
If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk
of electric shock.

2. MACHINE INFORMATION

Intended use
Your angle grinder has been designed for grinding
masonry and steel materials without the use of
water. For cutting, a special protection guard
must be used (not included)
Technical specifications
Model No AGM1067P AGM1068P AGM1072P
Mains voltage
Mains frequency
Power input 750W
Rated speed
Wheel disc for grinding
Diameter 115 mm
Bore 22 mm
Spindle thread M14
Weight
Sound pressure (L
Acoustic power (L
Vibration "Surface
grinding" a
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
• using the tool for different applications, or with
• the times when the tool is switched off or when
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-3
Fig. A
1. Spindle lock button
2. On/Off switch
3. Protection guard
Fig. B
8. Spindle
9. Mounting flange
10. Wheel disc (not included)
11. Clamping nut
220-240 V~
12. Spanner
13. Side handle
50 Hz
850W 750W
Assembly
11.000 /min
125 mm 100 mm
22 mm 16 mm
M14 M10
)
PA
)
WA
h,AG
different or poorly maintained accessories,
may significantly increase the exposure level
it is running but not actually doing the job, may
significantly reduce the exposure level.
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
1.9 kg
89 + 3 dB(A)
100 + 3 dB(A)
11.2 + 1.5 m/s
2
7