Replacing The Power Cable; Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL RT-TS 2231 UD Originalbetriebsanleitung

Anleitung_RT_TS_2231_UD_SPK1:_
GB
There is no push block supplied with the
saw! (Available from your specialist dealer)
Replace the push block without delay when it
becomes worn.
9.1.4. Making bevel cuts (Fig. 45)
Bevel cuts must always be used using the parallel
stop (7).
Set the blade (41) to the desired angle. (See
8.5.)
Set the parallel stop (7) in accordance with the
workpiece width and height (see 8.3.1)
Carry out the cut in accordance with the
workpiece width (see 9.1.1., 9.1.2 and 9.1.3.)
9.2. Using the slide (Fig. 46)
Set the slide to the desired angle (see 8.4)
Press the workpiece firmly against the stop rail.
Switch on the saw.
Push the slide toward the saw blade in order to
make the cut.
Important: Always hold the guided part of the
workpiece. Never hold the part which is to be
cut off.
Push the slide forward until the workpiece is cut
all the way through.
Switch off the saw again. Important: Do not
remove the offcut until the blade has stopped
rotating!
The standard end stop (47) can be used for
repeat cuts. To do this, flip down the end stop
and set it to the desired dimension by means of
the thumb screw (48).

10. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
11. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
11.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
24
22.09.2010 7:34 Uhr Seite 24
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
11.2 Maintenance
Important! Pull out the power plug first.
Remove dust and dirt regularly from the
machine. Cleaning is best carried out with a fine
brush or a cloth.
Never use caustic agents to clean plastic parts.
11.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

12. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.