Turning Button Beep On And Off; Resetting The Watch; Troubleshooting; Problems With The Gps - Timex MARATHON M434 Benutzerhandbuch

TuRNINg buTTON beep ON ANd Off

Select whether or not the watch emits a beep when any button is pressed.
1. Press MODE until SET displays.
2. Press + or - to select KEY TONE, then press OK.
3. Press + or - to select ON or OFF, the press OK.
4. Press MODE to exit.
When KEY TONE is ON, the
You can also set the button beep when setting the alarm. See

ReseTTINg THe WATCH

You can return all settings to their factory defaults. Your user profile and workout data are preserved.
• Press INDIGLO , MODE, START/SPLIT/+ and STOP/SAVE/- simultaneously and hold.
®

TROublesHOOTINg

Follow these steps to solve problems that may arise when using the watch.

pRObleMs WITH THe gps

hoW do i turn off the gpS?
If the timer is not running for 15 minutes, the GPS will turn off automatically.
To conserve battery life, you may turn off the GPS manually.
• Hold GPS ON/OFF to turn off the GPS.
Why Can't i get a Satellite fix?
To obtain a good satellite fix, the GPS needs a clear line-of-sight to the satellites.
• Go outside and move away from buildings or tall trees.
• Remain stationary.
• Point the bottom of the watch face toward the sky.

pRObleMs WITH THe bATTeRY

the battery indiCator doeS not matCh the aCtual Charge
If the display appears too light or the GPS shuts off unexpectedly, but the battery indicator appears full:
1. Allow the battery to run down completely so that the watch shuts off automatically.
2. Fully charge the watch without interruption.
NOTe: Even when the watch is not in use, fully charge the watch every 1 or 2 months to preserve battery life.

sAfeTY

CAuTION: Do not wear this watch while swimming. Prolonged submersion in water can cause electrical
shorting which may cause skin irritation and minor burns.

WATeR ResIsTANCe

The watch is water resistant to 30 meters.
Water-Resistance Depth
30m /98ft
*pounds per square inch absolute
If the watch is submerged, before using or charging, wipe the watch dry and allow to air dry completely.

CleANINg ANd sTORAge

You can clean the watch with a damp cloth and a mild detergent. Wipe dry completely before using or
charging.
NOTe: Do not use any chemical cleaners or solvents that may damage plastic components.
To avoid permanent damage to the watch, do not store the watch in extreme high or low temperature
environments for extended periods.
G
icon displays in the lower right of the display.
10
Setting the Alarm Time for more information.
p.s.i.a. *Water Pressure Below Surface
60