How To Start Your Watch; Water And Shock Resistance - Timex INDIGLO Gebrauchsanweisungen

ENGLISH

HOW TO START YOUR WATCH

To start your watch remove the plastic guard from
under the crown, then press the crown in against the
case. The second hand will begin advancing in one-
second intervals.
Some deep-depth water-resistant watches require
the setting crown to be screwed in to secure water-
resistance. If your watch case has a protrusion with
screw threads, the crown must be screwed in after
setting the watch.
To screw in, push the crown firmly against the
threaded protrusion and hold in while turning the
crown clockwise. Continue to screw in the crown
until it is tight. You will need to unscrew the crown
(counter-clockwise) before pulling it out the next time
you want to set your watch.
2
ENGLISH

WATER AND SHOCK RESISTANCE

If your watch is water-resistant, meter marking
(WR_M) is indicated.
Water-Resistance Depth
30m/98ft
50m/164ft
100m/328ft
200m/656ft
*pounds per square inch absolute
WARNING: TO MAINTAIN WATER-RESISTANCE,
DO NOT PRESS ANY BUTTONS OR PULL OUT
THE CROWN UNDER WATER UNLESS YOUR
WATCH IS INDICATED AS 200 METER WATER-
RESISTANT.
1. Watch is water-resistant only as long as crystal,
crown and case remain intact.
p.s.i.a. * Water pressure
Below Surface
60
86
160
284
3