Important Operating Instructions; Configuring Home City And Daylight Savings Time (Dst) - Timex COMMAND ENCOUNTER Benutzerhandbuch

•
In any mode, press (A) to illuminate backlight.
•
In any mode, press (B) for 2 seconds to return to Normal Time mode. After
approximately 1 hour, hands will automatically return to normal position if no button
is pushed.
•
In any mode, if hour and or minute hands are obstructing view of digital display, press
(A) and (B) buttons at the same time to temporarily move hands to an area where they
do not block digital display.
•
Hand icon will flash to indicate hands are not in current time location (Fig. 3).
•
Press (A) and (B) buttons at the same time to move hands back to normal position.
Fig. 3

IMPORTANT OPERATING INSTRUCTIONS

To begin using your watch, first it must be configured your Home City and daylight savings time
(DST) setting. It is important to note World Time mode data depends on proper setting of your
Home City, time of day and date*. Please take time to carefully set these.

Configuring Home City and Daylight Savings Time (DST)

•
Press (B) and scroll to 'TIME' mode.
•
Press and hold (D) until 'SET' flashes then disappears from display and current city code
appears and scrolls across display. You are now in Home City setting mode (Fig. 4).
Fig. 4
•
Press (C) to advance or (A) to scroll back through City Code list to find the one you
want. Pressing and holding (C) or (A) will advance City at a faster rate.
o Complete list of City Codes is located at the end of this manual.
•
Press (D) after you have selected your Home City to return to timekeeping mode.
* Once you have selected your City Code your watch uses UTC (Universal Time Code,
Greenwich Mean Time) to calculate current times in different time zones.
Page | 3