User Information; General; Symbols And Conventions; Instructions - Dick SM-100 Originalbetriebsanleitung

User Information

1
1. User Information
1.1
These operating instructions are part of the SM-100 belt grinder
with the serial number given on the type plate (the type plate is
located on the back of the belt grinder).
The operating instructions must be kept close at hand at all times.
It contains important information and instructions for safe, proper
and economic use of the belt grinder. It must have been read and
understood by each person before this person can be entrusted
with the following work using the belt grinder:
• putting into operation,
• operating,
• servicing.
The operating instructions must be followed during all work on and
with the belt grinder. Following them helps to prevent hazards, to
reduce repair costs and to increase the reliability and life of the belt
grinder.
The technical information and instructions for use in these operat-
ing instructions are up-to-date and correct on delivery of the belt
grinder. Friedr. Dick GmbH & Co. KG reserves the right to further
develop the design and to make changes without notice.
All directional information is given from the view of the user.
1.2

Instructions

Sequences of actions, which must be carried out in the given
order, are given as a numbered list. Example:
1 Instruction step 1.
2 Instruction step 2.
SM-100 belt grinder
4

General

Symbols and conventions