Skoda ISOFIX G 0/1 Gebrauchsanleitung Seite 47

- See to it that the connecting piece, which has been put
off, would not slide behind the car seat to its bottom
part (e.g. when pulling on the safety belt tail (D)).
- Unthread the shoulder-padding loop (H
der -arrow- and together with the released belt pull it out
through the belt lead-in from the rear part of the child car
GB
seat -detail 3, 4-.
- 16 -
- Pull the belt (H) as well as the shoulder-padding loop (H
through the new lead-in of the desired colour. - Set the
shoulder-padding loop (H
colour –arrow-.
Caution: The colour of the belt loop holder and the colour
of the belt lead-in must always be the same!
- Hang the belt (H) back on the connecting piece.
Important: It is unconditionally necessary that the belts
lay on the frame of the child car seat!
4. 2. Release of the safety belts
- 17 -
- With a finger of one hand lift the lever (F) -detail- and with
the second hand pull simultaneously on both the shoulder
safety belts (H) forward (do not pull on shoulder-pad-
ding).
4. 3. Stretching of the safety belts
- 18 -
- Pull on the tail of the safety belt (D).
- Do not pull upwards or downwards but directly for-
ward.
4. 4. Restraining the child with a belt in the seat
- 19 -
- Open the lock of the safety belt (G) of the child car seat by
pressing the red „PRESS" button.
- Release the safety belts (H) (see Fig. 4. 2.).
- Hang lock' s tongues on the right and left to rubber slings
-arrows- on the cover.
- Swing the crotch pad to the front.
) on a new holder of the desired
1
) from its hol-
1
1
)