Operation; Removing The Vehicle Body; B) Installing The Receiver Aerial Cable; Inserting The Battery Pack In The Vehicle - Reely Dragontail Bedienungsanleitung



9. Operation

a) Removing the vehicle body
The vehicle body is secured with holding clips which must be pulled out from the retaining pins. The vehicle body can
then be lifted off.

b) Installing the receiver aerial cable

The receiver aerial cable is normally rolled up upon delivery. Unroll the aerial cable completely and smoothen it
carefully.
Run the aerial cable through the aerial tube and stick the
aerial tube into the aerial mount on the vehicle (see arrow in
the illustration on the right). Simply let excess aerial cable
protrude loosely from the tip of the aerial tube.
A rubber cap might be enclosed for the aerial tube. Place it
on the tip of the aerial tube to prevent the cable from moving
out of position.
Make sure the aerial cable does not get into the
drive mechanism. Secure the aerial cable e.g.
with a cable tie.
Never shorten the aerial cable!
c) Inserting the battery pack in the vehicle
Pull out the safety clips from the battery holder and lift up
the battery holder.
Insert the battery pack into the battery holder of the chassis.
The connection cables should be installed on the side of
the speed controller in the vehicle so that they do not run
over the toothed belt.
Reattach the holder and reattach it with the previously
removed safety clips.
Caution!
The battery pack must not be connected to the
speed controller yet.
30