Baxi Luna HT 1.850 Gebrauchsanleitung Seite 99

13.4 ConneCtIng the outDoor temperature sensor
The SIEMENS model QAC34 outdoor temperature sensor (optional accessory) must be connected to terminals
7-8 of terminal board M2 in figure 9.
The procedures for setting the gradient of the temperature curve "kt" vary depending on the accessories
connected to the boiler.
a) Without Qaa73 room temperature control device:
The temperature curve "kt" must be selected by setting parameter H532 as described in section 15 "setting
the boiler parameters".
See graph 2 for selecting the curve referred to a room temperature of 20°C.
The chosen curve can be shifted by pressing the
value displayed by pressing the
graph 3 refers to the curve Kt=15).
Increase the value displayed if the room temperature required is not reached inside the premises for central
heating.
Graph 2
b) with Qaa73 room temperature control device:
The temperature curve "kt" must be selected by setting parameter 70 "HC1 gradient" of the QAA73 room
temperature control device as described in section 13.3 "QAA73: parameters which can be set by the instal-
lation engineer (service)".
See graph 4 for selecting the curve referred to a room temperature of 20°C.
The curve is shifted automatically on the basis of the room temperature set using the QAA73 climate con-
trol.
If the system is divided into zones, the temperature curve "kt" relating to the part of the system not control-
led by the QAA73 must be selected by setting parameter H532 as described in section 15 "setting the boiler
parameters".
InstructIons pertaInInG to the InstaLLer
button (2) on the boiler control panel, and modifying the
and . keys. See graph 3 for curve selection. (The ex­ample show in
tM = Flow temperature
te = composite outside temperature
sth = Kt curve
99
Graph 3
912.198.1 - GB