Description Of Keys - Baxi Luna HT 1.850 Gebrauchsanleitung

(2) This key can be pressed to set the central heating water output temperature as described in point
3-3.
(3) This key can be pressed to set the domestic hot water temperature as described in point 3-4.
(10) central heating mode operating key
The key can be pressed to activate four boiler central heating operating modes; these modes are
identified by a black cursor line underneath the relative symbol on the display, and are as follows:
"automatic mode"
Figure 2
a) automatic operation. Operation of the boiler is controlled by the timed program as described
in point 3-5.1 "Daily timed program for operation of the central heating system";
b) Manual operation at the maximum temperature set. The boiler comes into operation
regardless of the timed program set. The operating temperature is that set using the
(point 3-3: "Setting the max­imum central heating temperature");
c) Manual operation at minimum temperature. The operating temperature is that set in point
3-6: "setting the minimum central heating temperature".
The manual transition from positions a) and b) to position c) involves shut-down of the burner
and disconnection of the pump after the post-circulation delay interval (the factory setting for
this parameter is 10 minutes).
d) standby. The boiler does not work in central heating mode, although the antifreeze function
is still enabled.
(1) Domestic hot water on/off key: Press this key to activate or inhibit this function, which is identified
by the appearance on the display of two black dashes under the
(4) reset key. In case of a fault, referred to in point 3-7 "Faults and resetting the boiler", the boiler
can be restarted by pressing this key for at least two seconds.
If this key is pressed with no fault present, the display will show the message "e153", and the same
key has to be pressed again (for at least two seconds) to restart the boiler.
InstructIons pertaInInG to the user

3.1 DesCrIptIon of keys

Dash
active
symbol.
79
key
912.198.1 - GB