Use Of The Engine; Running-In Period; Oil / Changing Oil; Oil Capacity - Texas TD420 Bedienungsanleitung

Use of the engine

RUNNING-IN PERIOD

The first 20 hours is the running-in period for the engine. Therefore always follow the correct
guidelines for use of the engine.
1. After start, let the engine pre-heat at low revolutions and minimum load at least 5 minutes
before use
2. It is recommended to use the engine at 3.000 rpm and only 50% load the first 20 hours.
After 20 hours, the engine is capable to run with full load.
3. Change the oil after the first 20 running hours.
4. If the oil is changed after the first 20 running hours, it is only necessary to change for
every 20 running hours or minimum once every year.

Oil / changing oil

OIL

OIL CAPACITY

•
Always check the oil level when the engine is placed in a horizontal position.
•
Always check the oil level without fastening the oil stick.
TD420 - TD420E
0,75 Liter
CHANGING OIL
Oil should be changed in accordance with the user manual for the machine.
1. Let the engine run 5 minutes, so that the oil is heated. This makes the oil flow more easily
and it is easier to complete the oil change.
2. After 5 minutes the engine is turned off. Unscrew the engine's oil drain plug and the oil
runs out of the engine. Remember to keep an appropriate container ready.
3. Put the drain plug back in its place and new oil is added to the engine.
4. You add oil by removing the oil stick and adding the correct amount of oil.
Remember to dispose the used oil so that you are of no nuisance to the nature.
Use the correct oil for the specific time of year.
TD600- TD600E
1,1 Liter
Use your local recycling station.
TD900- TD900E
1,65 Liter
12