C) Placing The Receiver Aerials; D) Servo Installation; Checking The Control Functions - ModelCraft 20 92 37 Bedienungsanleitung

c) Placing the Receiver Aerials

The two aerials must be placed as straight as possible.
Place the aerials at a 90° angle to each other to ensure
best reception of the transmitter signal.
Place the aerials as far away from any electric components,
cables, metal and carbon fibre parts as possible.
Figure 4
d) Servo Installation (not part of the delivery)
The installation of a servo is always dependent on the particular model used. For specific information, refer to the
design documents of the model.
However, generally you should try to fasten the servos with screws in such a way that vibrations are minimised. This is
why rubber bushings with metal sleeves are usually included with the servos.
e) Checking the Control Functions
Connect the servos or speed or flight controller used in your model and the power supply to the receiver. Next, switch
on the transmitter and then the receiver. If you have connected everything correctly, the servos should also function
properly. If one or more functions do not react correctly, you can adjust the corresponding settings.
29