Taking Out Of Service - Agria CargoMaster 6400E Betriebsanleitung

CargoMaster 6400 E

15. Taking out of Service

With putting out of operation the batteries must be
attached to the battery charger - the batteries are then
supplied by a compensation charge.
Should the vehicle be put out of operation for a long
time it is recommendable to dismount the batteries
and to store them in a dry, frost-free place. The
batteries must be attached to the battery charger - the
batteries are then supplied by a compensation charge.
16. Repair
The repair of the appliance is allowed to competent
personnel only.
Replacement of the Drive wheels
To loosen the screws it is sensible to leave the vehicle
standing on its own wheels.
Lift the vehicle at the lower protection.
Remove the wheels with the help of a suitable take-off
device.
Replacement of the Battery
When working at the electrical installation the battery
must be disconnected.
When working at the battery follow the safety
instructions regarding the accumulators.
Should a battery replacement be necessary,
I
please do in any case respect the exact polarity.
A faulty polarization immeditately destroys the
electronic system.
- It is prohibited to throw the batteries into the fire;
W
- Do not short-circuit the connections of the
batteries;
- Charge the batteries in well ventilated locations
only;
- In case the skin comes into contact with
accumulator acid, immediately wash the affected
areas off with water;
- Batteries contain lead and must therefore be
disposed of as special waste.
agria-Werke GmbH • D-74219 Möckmühl • Tel. +49(0)6298/39-0 • Fax. +49(0)6298/39100 • e-mail: info@agria.de • Internet: www.agria.de
Replacement of the fuse ( 80 A ) in the electric
circuit of the motor
When working at the electrical installation the battery
must be disconnected.
The fuse is mounted in the battery bridge (C/43) (black
cable) and insulated by means of a shrinkage tube.
To replace the fuse the shrinkage tube must be cut
open.
By loosening the two screws M 5 x 5 the faulty fuse can
be removed and be replaced by a new one. When
mounting the fuse it is imperative to make sure that the
screws are fitted with spring washer or tooth lock
washer. Also, a shrinkage tube must be placed again
in any case.
Replacement of the fuse ( 6,3 A ) in the
charging current circuit
When working at the electrical installation the battery
must be disconnected.
The fuse is inside the fusebox (C/45).
Open the fusebox to replace the fuse (bayonet socket).
Replacement of the fuse ( 1,0 A ) in the
control circuit
When working at the electrical installation the battery
must be disconnected.
The fuse is inside the fusebox (C/45).
Open the fusebox to replace the fuse (bayonet socket).
Fig. C
45
41
41 Battery
42 Control
43 Fuse circuit of the motor
44 Fuse control circuit
45 Fuse charging current circuit
44
43
80 A
1,0 A
6,3 A
42
41
31