Performing The Pressing Operation - NovoPress AXI102 Betriebsanleitung

4. Align the pusher adaptor with the guide rod such as to ensure that the transverse holes are
on the same axis (Fig. 10).
CAUTION!
Damage to pusher tool and pusher adaptors if the bolt is not pushed in
correctly (Fig. 11)
An incorrectly inserted bolt may result in damage to the pusher tool and pusher
adaptors.
Therefore:
– Make sure that bolts are fully inserted and locked in place.
5. Lock the pusher adapter in place with the bolt (Fig. 10)
To do so:
Press the pin into the bolt and keep it pressed (1).
Push the bolt in fully (2).
Release the pin in the bolt.
CAUTION!
Damage to pusher tool and pusher adaptors (Fig. 12)
The pusher tool and pusher adaptors can be damaged by
Therefore:
– Make sure that adaptors have the same nominal width.
– Make sure that the matching nominal widths are lined up.
– Make sure that the system is press-fitted using the pusher tool and pusher adapters
from the system manufacturer.
6. Push the pusher adapter with the inscription 2 onto the guide rod in the direction of the arrow
and lock it using the bolt (Fig. 13).
7. Insert the battery.
9.2

Performing the pressing operation

CAUTION!
Faulty pressing!
Dirt, swarf, etc. in the contours of the pusher adaptors leads to a risk of faulty pressing.
Therefore:
– Ensure that there is no dirt, swarf, etc. in the contours of the pusher adapters.
Information!
To align the tool with the pipe, compliance with the system manufacturer's instructions
is essential.
• Fitting nominal widths that do not match
• Pressing a system from a manufacturer for which the pusher tool and
pusher adaptors have not been designed.
23
AXI102/AAP102
EN