Battery Level Indicator; Start-Up And Operation Of Axi102 - NovoPress AXI102 Betriebsanleitung

7.3 Battery
7.3.1 Removing the battery (Fig. 4)
Push in (1) the two release buttons (A) and then remove the battery (2).
7.3.2 Inserting the battery (Fig. 5)
Slide the battery into the device as illustrated until it clicks into place.

7.3.3 Battery level indicator

The 4 green LEDs (4) indicate the charge level of the battery. The number of LEDs lit up denotes
the battery charge. If the LED (2) is flashing the battery is empty and no further travel is possible.
7.4 AXI102/AAP102 and battery
Information!
The AXI102 expander and AAP102 pusher tool must only be operated
with 12 V DC lithium-ion rechargeable batteries. The 12 V battery must
only be used in the appropriate press devices.
Information!
The batteries are not charged at the factory.
Therefore:
– Charge the batteries before using for the first time.
Information!
Limited temperature range for charging and storing the batteries.
Therefore:
– It is imperative that the operating instructions for the battery charger are complied
with.
Behaviour of the press device after extended periods out of use or when changing the
battery:
If the press device is out of use for approx. 30 minutes or the battery is reinserted, it switches off.
No LED is lit up any longer. Press the start button (1) briefly to start the press device.
8

Start-up and operation of AXI102

8.1 Preparing AXI102 (Fig. 6)
CAUTION!
Damage to the expander
Using expander heads from other system suppliers may result in damage to the
expander. The pitch of the expander cones differs from one system supplier to another.
Therefore:
– Only use expander heads approved by the system supplier.
– Only use expanders with intact, clean expander heads.
21
AXI102/AAP102
EN