Symbols And Technical Data - EINHELL SPAS-10200/4+C Originalbetriebsanleitung

Anleitung_BT_IW_150_SPK1:_
as slip-on gloves made of leather or other non-
conductive materials to insulate your body against
the floor, walls, conductive parts of the machine and
the like.
If you use small welding transformers for welding in
places with an increase electrical risk, for example in
constricted areas with conductive walls, (tanks,
pipes, etc.), in wet areas (which make work clothes
wet) and in hot areas (perspiration on work clothes),
the output voltage of the welding set when idling
must not exceed 42 V (effective value). Therefore,
the appliance may not be used for these purposes
because its output voltage is higher than this.
Safety clothing
1. While working, the welder must protect his entire
body from radiation and burns by wearing
suitable clothing and a face guard.
2. Slip-on gloves made of a suitable material
(leather) must be worn on both hands. They
must be in perfect condition.
3. Suitable aprons must be worn to protect clothing
from sparks and burns. A safety suit and, if
necessary, head protection must be worn if
required by the type of work in question, e.g.
overhead welding.
4. The protective clothing used as well as all
accessories must be in compliance with the
"Personal safety equipment" EU Directive.
Protection from radiation and burns
1. Provide information about the risk to eyes at the
working site in the form of a poster with the
wording "Caution – do not look at the flames".
Workplaces are to be screened off wherever
possible so that personnel in the vicinity are
protected. Unauthorized persons are to be kept
away from the welding work.
2. The walls in the immediate vicinity of stationary
workplaces should not have a light color or a
sheen. Windows up to head height are to be
protected against radiation passing through them
or reflecting off them, for example by coating
them with a suitable paint.
14.10.2011 7:49 Uhr Seite 11

4. SYMBOLS AND TECHNICAL DATA

EN 60974-1
a
a
b
50 Hz
U 1
I max
1
U 0
I 2
Ø mm
IP 21 S
H
X
The product meets the requirements of EN 60974-
10, class A, meaning that it may only be used for
industrial applications. In unfavorable conditions the
product can cause electromagnetic interference.
GB
European standard for welding
sets for manual arc welding with
limited on time.
Single-phase static frequency
converter transformer rectifierr
Mains frequency
Mains voltage
Rated maximum mains current
Fuse with rated value in A
Rated idling voltage
Welding current
Electrode diameter
Symbol for falling characteristic
curve
Symbol for manual arc welding
with sheathed rod electrodes
Single-phase mains connection
Do not store or use the
appliance in wet or damp
conditions or in the rain.
Thoroughly read and understand
the operating instructions prior to
using the welder.
Protection type
Insulation class
On-load factor
Symbol for TIG (tungsten inert
gas) welding
11