Changing The Cover - be cool THUNDER iso-fix Gebrauchsanweisung

GB
THUNDER iso-fix
7

CHANGING THE COVER

Removing and Replacing the cover and belt
pads
a) Loosen the belts pads. (See adjusting the
height of the shoulder belts)
b) Loosen the cover all around. (Fig. 20)
c) Pull the belts, buckle tongues and buckle
through the cover.
d) Remove the cover.
e) After washing, attach the belt pads and
place the cover on the shell.
f) Thread the buckle, tongues and belts
through the cover and fasten the cover at the
release button/positioning handle.
g) Secure the cover on the pins.
h) Close the buckle and thread the belts
through the belt pads, cover and shell.
i) Connect the shoulder belts to the belt yoke.
j) Fasten the cover all around, behind the pins.
Checklist
For safety's sake read through this checklist
before you set off.
Check that the harness belt system fits
properly and tightly around your child and
that the shoulder belts are at the correct
height.
Check regularly that the belt in the baby car
seat is not damaged. If it is damaged do not
use your product in any circumstances and
contact your supplier or importer (see ad-
dress list in the service card).
Check that you have secured your baby car
seat with the seat belt.
If you have any questions, please contact
your supplier
Make sure that you have the following de-
tails to hand:
-Serial number underneath on the service
card.
-Mark and type of vehicle and seat on which
the baby car seat used.
-Age and weight of your child.
18
IM-1613.02 THUNDER isofix 30.7.15.indd 18 30/07/15 11:13