Choosing Where To Install The Platform; Installing The Platform In The Vehicle - be cool ZERO BASE Kurzanleitung

EN
Your new ZERO BASE Platform from BE COOL is an accessory that
has been designed to make installing the ZERO BASE baby carrier
easier in the car. The platform is fastened to the car with ISOfix
anchors so there is no need to fit the seat belts over the ZERO
BASE baby carrier.
The ZERO BASE Platform has passed the strict safety tests of
European Standard ECE R44/04.
This is a Semi-Universal ISOfix platform, in other words, it is
compatible with most vehicle seats. The approved vehicles list
shows which are completely compatible. An updated list can be
seen on our website.
It is very important that you read these instructions carefully
before using the ZERO BASE platform for the first time. Make sure
that everyone who is ever going to use the platform also knows
how to install it and use it correctly. It has been discovered that a
significant percentage of car seat users do not install their seats
correctly, understanding the instruction manual and following it
correctly is as important for safety as the actual seat.
Keep the instructions in the compartment on the platform and
consult them if in any doubt.
You can find on our web page: www.babybecool.es pictures that
show how to install and use all the BE COOL safety products.
16
You can also find a copy of these instructions in digital format.
IM 2009,01 ZERO BASE ins.indd 16

CHOOSING WHERE TO INSTALL THE PLATFORM

Not all systems are the same, so we advise you to check this in
the vehicle in which the platform is going to be installed. To install
the platform, read the instruction manual for your car, as this will
indicate which seats are compatible with the platform. The ZERO
BASE platform is compatible with the ISOfix categories: Classes
C, D and E.
The anti-rotation leg (2) is very important for safety, adjust it
properly so that it is supported by the floor of the vehicle. If the
supporting surface for the leg is not the actual vehicle chassis (a
storage compartment for example) do not install the platform on
this seat.

INSTALLING THE PLATFORM IN THE VEHICLE

1.a Place the platform on the vehicle seat with the anti-rotation
leg (2) and the ZERO BASE fastening guard (10) unfolded.
1.b Take the ISOfix fasteners out (3) turning the button (5) on the
front of the base.
1.c
Guide both fasteners (3) towards the ISOfix axles of your
vehicle and press until both sides are locked into place. Two
green signals will appear on the release buttons (4) indicating
that they are correctly fastened. If one or both indicators are
red, try it again.
Adjust the height of the leg (2) so that it is supported by the
1.d
floor of the vehicle, the indicator on the base of the leg (11) will
turn green.
19/6/18 19:13