Maintenance & Cleaning General; Changing The Cover - be cool Thunder Anleitung

f) If you want to alter the belts from or to the lowest positions,
place the THUNDER to the sleeping position.
g) If you want to alter the belts from or to the higher positions,
place the THUNDER to the sitting position.
h) Place the shoulder pads at the expected height and thread the
shoulder straps back through the shoulder pads, cover and
shell. (Fig. 18)
i) Connect the shoulder belts to the belt yoke. (Fig. 19-a)
MAINTENANCE & CLEANING GENERAL
a) The car seat can be cleaned by using lukewarm water and
soap. Do not use aggressive cleaners like abrasives or thinner.
b) The cover should be washed by hand at a maximum tempera
ture of 30ºC. Do not put it in the dryer.
c) It is advised to buy an extra cover when purchasing the car seat
that you can continue using it when one cover is being washed.
Step 1: Take the car seat out of your car; ensure your entire baby's
car toys are put away before you begin cleaning it.
Step 2. Suck up food particles and dirt with a cordless vacuum. If
possible, use a portable vacuum cleaner's furniture attachment to
clean the small, hard-to-reach areas of the car seat.
Step 3. Clean off the plastic portions of the seat with gentle soap
and water.
IM 1422.03 THUNDER INST.indd 23
Step 4. Remove the entire car seat cover, if possible, and run it
through your washing machine gentle cycle.
Stpe 5. Spot clean the stained spots on the car seat if you
cannot remove the cover; make sure you can use the soap
on the car seat's material by checking the package's
guidelines.
Step 6. Reinstall the clean car seat in your car, and take special care
that all parts of the car seat being present and installed safely and
correctly.

CHANGING THE COVER

Removing and Replacing the cover and belt pads
a) Loosen the belts pads. (See adjusting the height of the
shoulder belts)
b) Loosen the cover all around. (Fig. 20)
c) Pull the belts, buckle tongues and buckle through the cover.
d) Remove the cover.
e) After washing, attach the belt pads and place the cover
on the shell.
f) Thread the buckle, tongues and belts through the cover
and fasten the cover at the release button/positioning handle.
g) Secure the cover on the pins.
EN
23
20/6/18 8:52