Specifications - Makita HM1202C Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch lever
2-1. Adjusting dial
3-1. Power-ON indicator lamp (green)
3-2. Service indicator lamp (red)
4-1. Side handle
4-2. Clamp nut
5-1. Side handle base
5-2. Clamp nut
6-1. Bit grease

SPECIFICATIONS

Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for chiselling work in concrete, brick,
stone and asphalt as well as for driving and compacting
with appropriate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.46 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.6 dB(A)
Wear ear protection
Explanation of general view
6-2. Bit shank
7-1. Bit
7-2. Tool holder cover
9-1. Change ring
11-1. Commutator
11-2. Insulating tip
11-3. Carbon brush
12-1. Screwdriver
12-2. Rear cover
Model
Overall length
Net weight
Safety class
) : 85 dB(A)
pA
) : 99 dB(A)
WA
HM1202
1900 min
9.9 kg
ENE045-1
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : chiseling
ENF002-2
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENF100-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
ENG905-1
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
12-3. Screws
13-1. Screwdriver
13-2. Brush holder cap
14-1. Screws
15-1. Socket wrench
15-2. Crank cap
16-1. Hammer grease
HM1202C
-1
950 - 1,900 min
578 mm
II
) : 16.5 m/s
h,CHeq
2
-1
10.0 kg
ENG900-1
2
ENG901-1