Maintenance & Servicing; Warranty - Stuart SRT6D Bedienungsanleitung

power back on. The display will temporarily
show 88:88 then OFF. Using the control knob
turn the unit on, the display will show nn:ss for
minutes and seconds, H:nn for hours and
minutes and nn for minutes, turn the control
knob to select the desired timer unit and turn
the unit off by the control knob, OFF will be
displayed. When the unit is next used the timer
will have been altered to the set unit.
Maintenance & Servicing
WARNING: Ensure the unit is
disconnected from the mains electricity
supply before attempting maintenance or
servicing.
Periodically clean the instrument using a damp
cloth and mild detergent solution. Do not use
harsh or abrasive cleaning agents.
Any repairs or replacement of parts MUST
be undertaken by suitably qualified
personnel.
The following spares and accessories are
available from your laboratory dealer.
Description
Stacking system
For a comprehensive list of parts required by
service engineers conducting internal repairs and
a service manual, please contact the Technical
Service Department of Bibby Scientific Ltd.
quoting both the model and serial number.
Only spare parts supplied or specified by Bibby
Scientific Ltd. or its agents should be used.
Fitting of non-approved parts may affect the
performance and safety features designed into
the instrument.
If in any doubt, please contact the Technical
Service Department of Bibby Scientific Ltd. or the
point of sale.
Bibby Scientific Ltd.
Stone, Staffordshire ST15 0SA
United Kingdom
Tel: +44 (0)1785 812121
Fax: +44 (0)1785 813748
e-mail info@bibby-scientific.com
www.bibby-scientific.com
Catalogue Number
SRT/STACK

Warranty

Bibby Scientific Ltd warrants this instrument to
be free from defects in material and
workmanship, when used under normal
laboratory conditions, for a period of three (3)
years. In the event of a justified claim Bibby
Scientific will replace any defective component or
replace the unit free of charge. This warranty
does NOT apply if damage is caused by fire,
accident, misuse, neglect, incorrect adjustment
or repair, damage caused by incorrect
installation, adaptation, modification, fitting of
non approved parts or repair by unauthorised
personnel.
3