Operation; Installation - Conrad 75 03 69 Bedienungsanleitung

The DC voltage source has to be switched
off.
plug: 5.5 / 2.1 mm
Please observe correct polarity.
If necessary, verify the polarity with a mea-
suring instrument.
Connect the video input with the BNC jack (7). If your
monitor/TV is only equipped with a cinch input
You have to use an adapter (BNC to cinch).

Operation

After connecting the video output and the voltage sup-
ply, the camera is ready for operation.
Switch on the DC source.
Switch on the monitor/TV and select the input to which
the camera is connected (e.g. AV input on the TV).
The image of the camera appears on screen.
If, contrary to all expectations, no image appears
on screen or another failure occurs, immediately
26
Commissioning
To ensure proper commissioning of the
device, please read this operating manu-
al carefully before using the product!

Installation

Choose a place of installation where the camera is not
exposed to direct sunlight, vibrations, dust, heat, cold
and humidity.
Do not install the product near devices with strong mag-
netic fields such as e.g. mobile phones, walkie-talkies,
electric engines etc.
These devices might affect the image quality.
Direct sunlight or bright illumination might affect the
camera images and make it difficult to watch the
images.
Take this into consideration when choosing a pla-
ce of installation.
Look for a suitable place to be observed by means of the
camera.
23