Conrad 75 03 69 Bedienungsanleitung Seite 24

The recommended height of installation of the camera
objective (2) is approx. 1.8 m.
The height of installa-
tion depends on the
object to be observed.
Before installation, con-
nect the camera and check the respective cam-
era image at the monitor/TV in order to verify if
the area to be observed is indicated. Proceed as
described under "Connection" (next chapter).
To adjust the camera
image, you can align the
support vertically
horizontally by releasing
the screws (5).
To obtain a greater distance to the wall, use the
spacer (4).
Use the drilling holes of the base plate (3) as drilling
template.
Make sure that there are no electric lines,
water conduits etc. at the intended drilling
holes.
24
or
Fasten the base plate (3) with the enclosed screws.
Use dowels, if necessary.
Use a suitable screwdriver.
Fasten the thread (1) of the camera at the camera sup-
port with screws and fix the screw joint with the nut (6).
Connection
Always use a DC voltage source with 12V
output as power supply. Never try to operate
the camera at a different voltage.
The DC source has to supply 140 mA as
minimum charge. Never overcharge the
voltage source!
The camera is connected with
the monitor/TV via a BNC line.
For the voltage supply, the
camera is equipped with a low-
voltage jack.
jacks: BNC jack (7):
low-voltage jack (8):
Connect the DC voltage source with the low-voltage
jack (8).
video signal
voltage supply
25