Led Strip Light Installation Instructions; Features And Tips; Initial Start-Up; Saltwater Aquariums - Fluval Roma Led Gebrauchsanleitung

LED STRIP LIGHT INSTALLATION INSTRUCTIONS

WARNING: Disconnect the plug of all electrical equipment used for the aquarium, before placing your
hands in aquarium water and/or performing any maintenance of any kind.

Features And Tips

Access Lids
The canopies are equipped with 2 Access Lids. This allows easy access to your
aquarium.
Optional Extra: Opening for Nutrafin Nutramatic 2x Fish Feeder
A replacement canopy rear lid is available including an opening for the use of a Nutrafin Profeed fish-feeder.
Pull to remove the plastic plug and access the compartment. To close, press the plastic plug in its place. (See
replacement parts section for order codes)

Initial Start-Up

1. Carefully place the Led Strip Light (C) on the runner of the top frame in the final position. (pict. 1)
2. Hook up the lighting unit to the LED Driver with its connector. (pict. 2)
3. Place the aluminium beam (B2) and the front and rear access lids (B1) on the aquarium top frame
Ensure that the electric cord and plug does not get wet. (pict. 3)
WARNING: Do not plug in the LED Strip Light if there is water on parts not intended to be wet.
1
Switching the LED Strip Light On and Off
It is recommended to use the line cord switch to turn the LED lighting on or off.
The LED Strip Light does not illuminate
If the LED Strip Light does not illuminate, please proceed as follows:
PROBLEM
Missing connection of the LED Driver to the power outlet
The lighting is
not working
Missing connection of the lighting unit to the LED Driver
If the problem is not solved after following the above, please contact your Hagen retailer.

Saltwater Aquariums

It is commonly known that salt water is far more corrosive, conductive (of electricity) and generally degrades
both plastic and metal parts at an accelerated rate versus fresh water. To minimize salt accumulations on the
Fluval Canopy and on the LED Strip Light, it is recommended to take note of the following helpful tips:
1. Make sure filter outputs do not spray above the water surface, position them below the water surface with a
slight downward angle, but still allow for surface movement (contributes to oxygenation).
2
CAUSE
3
SOLUTION
Connect the LED Driver to the power outlet
Connect the lighting unit to the LED Driver with its
connector
9