Aquarium Glass Tank Instructions - Fluval Roma Led Gebrauchsanleitung

5. CAUTION – Always unplug or disconnect all appliances in the aquarium from electricity supply before plac-
ing hands in water, before putting on or taking off parts and whilst this LED Strip Light is being installed, main-
tained or handled. Never yank cord to pull plug from outlet. Grasp the plug and pull to disconnect. Always
unplug an appliance from an outlet when not in use.
WARNING: The line cord Switch on the LED Strip Light cannot be considered a safety switch.
6. Do not use an appliance for other than intended use (i.e. don't use on swimming pools, garden ponds, bath-
rooms, etc.). The use of attachments not recommended or sold by the appliance manufacturer may result in
a dangerous situation. Do not try to repair any product component: in case of damage replace the damaged
component with original spare parts
7. IMPORTANT: This is a non submersible AQUARIUM LUMINAIRE (LED Strip Light) suitable FOR INDOOR
USE ONLY designed to be assembled onto FLUVAL ROMA Top Cover Frames Only. For Fresh and salt
water aquariums with max 35 °C water temperature. Do not install or store the appliance anywhere where
temperatures may drop below freezing.
8. IMPORTANT: Make sure that the LED Strip Light is securely and correctly installed before operating it and
that the minimum distance of water from the LED Strip Light is 15 mm. This LED Strip Light must never oper-
ate in water.
Fill the aquarium up to level indicated on the label situated on the
inside of the aquarium's top frame.
IMPORTANT: Do not over fill. Overfilling the aquarium can
cause water to pass under the top frame which then runs down
the outside of the aquarium.
WARNING: Do not plug in the LED Strip Light if there is water on parts not intended to be wet.
WARNING: Do not place any object(s) on the LED Strip Light. Ensure sufficient air space around the
LED Strip Light. The safety of this appliance is only ensured provided that it has been properly installed.
9. Read and observe all the important notices on the appliance.
10. If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes
or watts than the appliance rating may overheat. Care should be taken to arrange the cord so that it will not
be tripped over or pulled.
11. SAVE THESE INSTRUCTIONS

AQUARIUM GLASS TANK INSTRUCTIONS

Read Thoroughly Prior To Installation
The Fluval Roma aquarium glass tank comes complete with bottom and top plastic frames glued to it. Do not
try to remove top and bottom frames.
Although the glass tank was manufactured with the maximum care and the most advanced techniques, we still
recommend making a simple inspection prior to the installation to verify that unexpected events during handling
and transportation have not damaged the tank or impaired its water-tightness.
1) Make an initial visual inspection of the glass tank to check for damage or cracks.
2) If the visual inspection does not show any damage, fill the tank with 5cm (2") of water, wait 10 minutes and
check for leaks.
3) Add another 5cm (2") and repeat this process until you are sure there is no sign of any leak.
4) If no leak is detected, proceed with the normal aquarium set up.
The tank is made of glass, always handle it with the utmost care. Make sure to lift it by the base, never
by the top frame.
Never attempt to move or transport the tank if it is not completely empty of water or any other material.
Before handling the Aquarium tank and Cabinet, ensure you have sufficient manpower to move them
without any risk.
5