Placing The Aquarium With Its Cabinet In The Final Location; Easy Connection System Instructions; Installing Water Intake/Output With "Easyconnect" System - Fluval Roma Led Gebrauchsanleitung

Always take care not to damage the seals at the edges of the glass panels while maintaining your
aquarium, ie with planters or algae scrapers.
Never use toxic or aggressive substances to clean your aquarium, such as household detergents.

Placing The Aquarium With Its Cabinet In The Final Location

Location of the aquarium is very important. Place the aquarium away from direct sunlight. This will reduce the
chances of excessive algae build-up and avoid overheating the aquarium by the sun's rays. Keep your Fluval
Roma Aquarium away from other sources of heat (air ducts, radiators, etc.) for proper temperature maintenance.
Drafts should also be avoided. Do not locate your Fluval Roma Aquarium where water spills will cause damage.
You MUST place the Fluval Roma Aquarium on the appropriate Fluval cabinet which was designed
with the correct dimensions and structure to bear the weight of the aquarium full of water. The use of
different cabinets, articles of furniture, TV stands, etc. WILL invalidate your guarantee.
IMPORTANT: Fluval Roma Cabinets are designed to support the total weight of the aquarium (please find below
a table showing the approx. height of filling of the tank and approx. weight of the aquarium full of water (rocks,
decorations or gravel have not been considered).
MODEL
Fluval Roma 90 60 x 35 x 45 cm (23.6 x 13.8 x 17.7")
Fluval Roma 125 80 x 35 x 45 cm (31.5 x 13.8 x 17.7")
Fluval Roma 200 100 x 40 x 50 cm (39.4 x 15.7 x 19.7")
Fluval Roma 240 120 x 40 x 50 cm (47.2 x 15.7 x 19.7")
WARNING. Assure that the selected position has an even and level surface which is able to support the total
weight of the aquarium full of water and the cabinet. Place your new Fluval Roma Aquarium and Cabinet close
to an electrical outlet. After placing the Cabinet, assure that it is perfectly level by using an adequate spirit level.
IMPORTANT: Place the aquarium tank directly on the cabinet without any additional
support or damper in between. NEVER insert any lining (eg Polystyrene) between
cabinet and aquarium.
• Peel off the protective film on the decor strip (Only applies to gloss black decor strips)
TANK WARRANTY
Please see the enclosed Care Guide for warranty and registration details.

EASY CONNECTION SYSTEM INSTRUCTIONS

This section only applies to Roma Aquariums with "EasyCon-
nect" System and Fluval External filter. If your Aquarium Kit is
equipped with a Fluval Internal filter, go directly to "Fluval Fil-
ter installation" chapter.
Installing water intake/output with "EasyConnect"
system
Some Fluval Roma aquarium models feature the new and innovative "EasyConnect"
system, which allows the direct connection of the tank to the external filter through
the bottom glass by means of special fittings. Normally, the same type of connection
is achieved through specially-made devices, which are complex and require the in-
tervention of expert technicians. On the contrary, in a few minutes the EasyConnect
system can be easily and safely installed, giving your aquarium the most profes-
sional and clean solution.
Before proceeding, identify and count all parts required by referring to the
exploded view in the side illustration. If any part is missing, do not proceed
with the installation but contact your local supplier.
6
Placing the aquarium with its cabinet in the final location
Location of the Aquarium is very important. Place the aquarium away from direct sunlight. This will reduce the
chances of excessive algae build-up and avoid overheating the aquarium by the sun's rays. Keep your Fluval
TANK DIMENSIONS
Aquarium away from other sources of heat (air ducts, radiators, etc.) for proper temperature maintenance. Drafts
should be avoided as well.
Do not locate your new Fluval Aquarium where water spills will cause damage.
This cabinet was specifically designed with the right dimensions and structure to bear the weight of the
Fluval Aquarium supplied, full of water. The use of different cabinets or supports may cause an unsafe
condition.
WARNING. Assure that the selected position has a surface which is able to support the total weight of the
aquarium full of water and the cabinet.
The position selected should have an even and level surface. Place your new Fluval Aquarium and Cabinet close to
an electrical outlet.
After placing the Cabinet, assure that it is perfectly level by using an adequate spirit level. If
necessary your Fluval cabinet features special feet which can be easily regulated by the tool
supplied with the cabinet.
At the end of the regulation, the cabinet should be level and stable.
IMPORTANT: Place the aquarium tank directly on the cabinet without any additional support or damper
in between. NEVER insert any lining between cabinet and aquarium. In case fine adjustment is required to
make the aquarium level, use cabinet feet for regulation.

Installing water intake/output with "EasyConnect" system

All Fluval Vicenza and Venezia aquariums feature the new and innovative
"EasyConnect" system, which allows the direct connection of the tank to the
external filter through the bottom glass by means of special fittings.
Normally, the same type of connection is achieved through specially-made
devices, which are complex and require the intervention of expert techni-
cians. On the contrary, in a few minutes the EasyConnect system can be
easily and safely installed, giving your aquarium the most professional and
clean solution.
Before proceeding, identify and count all parts required by referring
to the exploded view in the side illustration. If any part is missing,
do not proceed with the installation but contact your local supplier.
Before proceeding, check stems (A) for the presence of all 3 rubber
rings (C). Do not proceed with the installation if one of the rubber
rings (C) is missing but contact your local supplier.
Connector Stem's
Rubber Rings (C)
HEIGHT OF FILLING (up to the
max water level line)
41.5 cm (16.3")
41.5 cm (16.3")
46 cm (18.1")
46 cm (18.1")
Tank opening
Plug (P)
Plug (Q)
9
WEIGHT OF AQUARIUM
FULL WITH WATER
105 kg (231 lb)
138 kg (304 lb)
222 kg (489 lb)
265 kg (584 lb)
Output
Nozzle (N)
Output
Stem (B)
Intake Strainer (S)
Connector
Stem (A)
Ring Nut (R)
OUTPUT INTAKE
GROUP GROUP